Re: flat coil ?

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "Barton B. Anderson by way of Terry Fritz <twftesla-at-qwest-dot-net>" <tesla123-at-pacbell-dot-net>

Hi Chris,

1.6mm = 0.063 inches (near 14 awg). 2000 feet wound from center (1/8"
screw) outward should yield (near): outer diameter of  44.23 inches, 343
turns, 5.2 ohms, and about 44mH.

Take care,
Bart

Tesla list wrote:

> Original poster: "Chris Swinson by way of Terry Fritz
<twftesla-at-qwest-dot-net>" <exxos-at-cps-games.co.uk>
>
> Hey all,
>
> I am just about to build a large flat secondary coil.  The wire length will
> be 2000ft, the wire dia is 1.6mm. I *think* this will be 500 turns at about
> 4foot dia.  Anyone got any ideas if that sounds about righ before I wind the
> thing ?
>
> Thanks,
> chris