Re: ballast bobbin...again

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "Jim Lux by way of Terry Fritz <twftesla-at-uswest-dot-net>" <jimlux-at-earthlink-dot-net>

boiling (or just hot) water also works well with PVC.  We used to use steam
from a low pressure boiler, too..

----- Original Message -----
From: "Tesla list" <tesla-at-pupman-dot-com>
To: <tesla-at-pupman-dot-com>
Sent: Tuesday, May 01, 2001 8:31 PM
Subject: Re: ballast bobbin...again


> Original poster: "Metlicka Marc by way of Terry Fritz
<twftesla-at-uswest-dot-net>" <mystuffs-at-orwell-dot-net>
>
> chris,
> you could put your pvc pipe in the oven for a while at about 250, once
> warm it might slide right on your core section?
> i've "kinked" quite a few lengths of pvc by heating to much so you could
> end up with a nice bobbin? maybe a layer of wax paper so it slips back
> off nice.
> marc m.
>
>
>