Working with Plexiglas

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "Gregory Hunter by way of Terry Fritz <twftesla-at-qwest-dot-net>" <ghunter31014-at-yahoo-dot-com>

Dear List,

I sometimes use Plexiglas for Tesla coil components,
but I still haven't figured out how to work the stuff.
 When I saw it with an electric jigsaw, the cut tends
to fuse back together after the blade has passed. 
When I finally do get the stuff cut, I have a rough
edge that defies my best efforts to smooth & polish
it.  What's the secret to cutting Plexiglas sheet? 
How do I get a professional-looking finish on the
edges?  What's the best glue to use with it?  How do I
use power tools on it without melting it?

If the explanations get really long, or get into
subjects not of general interest to TC builders,
kindly reply off-list.

Regards,

Greg
http://hot-streamer-dot-com/greg

__________________________________________________
Do You Yahoo!?
Get personalized email addresses from Yahoo! Mail
http://personal.mail.yahoo-dot-com/