Re: Flyback Xfmr

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "Jason Petrou by way of Terry Fritz <twftesla-at-qwest-dot-net>" <jasonp-at-btinternet-dot-com>

I think that the general concensus is to put a new primary on it, or find
the lowest resistance of the pins.

Good luck,
Jason
----- Original Message -----
From: "Tesla list" <tesla-at-pupman-dot-com>
To: <tesla-at-pupman-dot-com>
Sent: Monday, June 25, 2001 7:53 AM
Subject: Re: Flyback Xfmr


> Original poster: "by way of Terry Fritz <twftesla-at-qwest-dot-net>"
<Kidd6488-at-aol-dot-com>
>
> Hi, I also have a flyback xfrmr that I'd like to use for a JL, or a small
TC.
> It is in a enclosed case, and paart of the core sticks out. There are the
> usual two HV Leads on top. On the bottom, there are a total of nine pins.
It
> is a circualar setup. On one side, there are three pins, which I think is
the
> flyback.  On the other side, there are five wires, with two of them
soldered
> together, making it four pins. Away from this "circle", there are two
other
> pins, which appear to go up to a circuit board with two knobs: "screen"
and
> "focus". This flyback came out of a 25" color TV.
>
> -- Jonathon Reinhart
>
>
>
>
>
>
> In a message dated 6/23/01 08:13:34 PM Eastern Daylight Time,
> tesla-at-pupman-dot-com writes:
>
>
> >
> > >
> > > Hi all (Sorry I know this is a bit OT)
> > >
> > > I recently pulled apart an old telly to get at the flyback
Msnip...