Re: Smooth coatings on the secondary

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "by way of Terry Fritz <twftesla-at-uswest-dot-net>" <FutureT-at-aol-dot-com>

In a message dated 4/24/01 1:51:57 PM Eastern Daylight Time, FutureT writes:

>  Some sandpapers can be used with water,
>  which helps to prevent clogging the sandpaper.......snip

.... and also use a sanding block to hold the sandpaper.  This
will make the surface come out "flat" rather than bumpy.  Judge
the angle as you sand, so you sand the highest spots first.  As
you sand down to the proper surface level, be sure not to cut
through the coating to the wire beneath, etc......

John