Re: Safety gap electrodes

["Roderick Maxwell" <maxz-at-xxxxxxxxxxx> (by way of Terry Fritz <twftesla-at-xxxxxxxxxx>)]

----- Original Message -----
From: "Tesla list" <tesla-at-pupman-dot-com>
To: <tesla-at-pupman-dot-com>
Sent: Tuesday, October 31, 2000 5:43 PM
Subject: Safety gap electrodes


> Original poster: Esondrmn-at-aol-dot-com
>
> I am working on a new sync rotary gap and want to install a new safety gap
> across the rotary.  I plan on setting the gap to approximately .450".  I
have
> used # 10 copper wire for this in the past with 1.0" dia. loops on each
end.
> I would like to use 1.0" to 2.0" round copper or brass electrodes for the
new
> safety gap.  Does anyone know where I can get these?  Hopefully somewhere
> that does not require a $25.00 minimum order.
>
> Thanks, Ed Sonderman
>
>

  Just go down to a well stocked hardware store.
Look in the cabnet hardware section and buy some drawer pulls (drawer
handles).




Frankenstein's Helper

Max