Re: Using Printed Circuit Boards

To: tesla-at-pupman-dot-com
Subject: Re: Using Printed Circuit Boards
From: "Malcolm Watts" <malcolm.watts-at-wnp.ac.nz> (by way of Terry Fritz <twftesla-at-uswest-dot-net>)
Date: Tue, 21 Mar 2000 18:49:43 -0700
Approved: twftesla-at-uswest-dot-net
Delivered-To: fixup-tesla-at-pupman-dot-com-at-fixme

Hi Mark,
               I designed and made PC Bds for my MMCs. 

Regards,
Malcolm

On 21 Mar 00, at 7:56, Tesla List wrote:

> Original Poster: "Mark Broker" <broker-at-uwplatt.edu> 
> 
> Hello again,
> 
> I've seen a lot of great coils on the Web.  But I noticed that no one (that
> I can recall) used a printed circuit board for any of their electronics
> (MMC, NST protection circuit, ect).  I saw a lot of perf board, though...
> Anyways, one of my good friends makes printed circuit boards as a second
> home-job/hobby.  He has pretty much offered to donate the board and the
> materials to make some nice boards for my TC.  I'd intended to use them for
> my MMC (hardwire the caps into strings, but leave the strings to be
> connected via standard wire) and also in my NST protection circuit.  I had
> intended to use wide lines (1/4"+) on the boards.
> 
> Since I haven't seen any pc boards on the Web, I thought that there may be
> a drawback to using them in TC operation (not just an availability
> problem).  So is there a problem here?
> 
> Thanks
> 
> Mark B
> 
>