Re: sync motor question

["Metlicka Marc" <mystuffs-at-orwell-dot-net> (by way of Terry Fritz <twftesla-at-uswest-dot-net>)]

terry,
thank you for the good news, i forgot to put in that this motor uses a
10mf cap also. will this hurt my plans any? i also checked the solid al.
disk pulley on it for shaft runout and came up with less then 001"
runout, will i have to shim this any tighter?
i did a quick pulley ratio check and this thing spun the blower at
11,720 rpm, though the motor is a small dia. 3.75" do you think that
this would be an indication that the bearings will take maybe a 8" disk?

marc