[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Arc pulling, was Touching/Sitting on your coil



Original poster: "Paul Mathus" <pmathus-at-learningco-dot-com>

     Interesting.  I have pulled arcs off my coil using a 5' piece of 1"
     pvc pipe.  I ran a piece of magnet wire from the fence where I ground
     my coil to the end of the pipe and electrical-taped it on, with about
     4" sticking out.


That's the difference. With a wire to Ground you should get no tracking. I 
do it without the wire.

     This worked fine for pulling arcs off the coil, and there was no
     tracking in the pipe.  This sounds very similar to what Richard was
     doing, except for the pipe material.  Perhaps because your coils are
     more powerful than mine?  Or is ABS more succeptible to tracking? It
     is black here in the states.

DO NOT USE BLACK PVC (or ABS) FOR ANY TYPE OF JESUS STICK! The Black is 
frequently made with Carbon and your "Insulator" will bite you. Use White, 
clear, Green, and if you're a little daring grey. But never Black. I believe 
Grey is safe, but I've never used it.


I am running a 12/60 nst coil.

     paul mathus




Christopher A. Boden Geek#1
President / Founder
The Geek Group
www.geekgroup-dot-org
Because the Geek shall inherit the Earth!

________________________________________________________________________
Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail-dot-com