Re: Winding Primaries (fwd)

["Tesla list" <tesla-at-xxxxxxxxxx>]

Original poster: Tesla List Moderator <mod1-at-poodle.pupman-dot-com>



---------- Forwarded message ----------
Date: Wed, 06 Dec 2000 13:06:02 -0800
From: Jim Lux <jimlux-at-earthlink-dot-net>
To: Tesla list <tesla-at-pupman-dot-com>
Subject: Re: Winding Primaries (fwd)

or just run a bunch of DC current through the primary, making it hot and
softening the plastic, so that the plastic is "welded" back together...

Another use for that welder you needed... 

Tesla list wrote:
> 
> Original poster: Tesla List Moderator <mod1-at-poodle.pupman-dot-com>
> 
> ---------- Forwarded message ----------
> Date: Wed, 06 Dec 2000 14:53:38 -0500
> From: Metlicka Marc <mystuffs-at-orwell-dot-net>
> To: Tesla list <tesla-at-pupman-dot-com>
> Subject: Re: Winding Primaries (fwd)
> 
> hi simon,
> you could always cut the former down the length at the center line of
> the holes, then place the tubing into the bottom half holes and put the
> top half back on. you could drill small holes down between the tubes and
> push plastic "swizzle" sticks or plastic dowel rods in to them for a
> nice tight pin.
> just a thought.
> marc