Re: Out of round PVC


You are going to fit a disc at the top and bottom end of the coil, to
stop internal arching, so if you fit them to go inside the tube, and
make them really round, that would force the tube into roundness at the
top and bottom.

While you are at it, make a few more discs, and ram them down the tube
with a spacing , say, like the diameter, that will probably make the
tube nice and round again.

Cheers, Finn Hammer

Tesla List wrote:
> Original Poster: "Bob Berg" <berg_bob-at-hotmail-dot-com>
> I just bought a 10 ft length of 6" PVC Drain pipe to  wind my new seconday.
> the way the PVC was strap in the bundle its a little out of round, somewhat
> oval like.  Does anyone know of a way to make it round again?
> Thanks
> Bob
> ________________________________________________________________________
> Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail-dot-com