Re: Flyback Jack

• To: tesla-at-pupman-dot-com
• Subject: Re: Flyback Jack
• From: "Bill Noble" <william_b_noble-at-email.msn-dot-com> (by way of Terry Fritz <twftesla-at-uswest-dot-net>)
• Date: Tue, 14 Sep 1999 11:47:30 -0600
• Approved: twftesla-at-uswest-dot-net
• Delivered-To: fixup-tesla-at-pupman-dot-com-at-fixme

if you want a flyback that isn't potted, find an old color TV from the mid
to late 1960s, or an old B&W TV - color had higher voltage (30KV vs 10KV) -
a tube type TV will have an unpotted flyback - just cut the primary windings
off, leaving the secondary, and wind your own primary on it - a few turns, a
center tap, and a few more turns (10 each side of the tap seems typical).
----- Original Message -----
From: Tesla List <tesla-at-pupman-dot-com>
To: <tesla-at-pupman-dot-com>
Sent: Saturday, September 11, 1999 10:18 AM
Subject: Flyback Jack


> Original Poster: "Nathan Howard" <nhoward-at-pdq-dot-net>
>
> How is Everyone,
>
> I was hoping someone could explain how to identify the terminals on  a
> flyback.  The transformers I have found so far have all been encased in
epoxy.
> Is there some way  to unpot these? This  would not be necessary if I could
> identify the terminals properly.  Some power supply circuits I have seen
have
> less terminals than my transformer.  Could someone point me towards a good
> schematic for a flyback power supply.
>
> Thanks form Houston,
> Nathan
>
>
>

• Prev: RE: Grounding a TC
• Next: Re: R-C-R restrictor, uh... filter
• Index(es):
  • Main
  • Thread