Re: Modifying a 1725 RPM motor

• To: tesla-at-pupman-dot-com
• Subject: Re: Modifying a 1725 RPM motor
• From: FutureT-at-aol-dot-com (by way of Terry Fritz <twftesla-at-uswest-dot-net>)
• Date: Sat, 16 Oct 1999 07:41:23 -0600
• Approved: twftesla-at-uswest-dot-net
• Delivered-To: fixup-tesla-at-pupman-dot-com-at-fixme

In a message dated 99-10-15 07:16:25 EDT, you write:

<< 
> I purchased a refurbished Baldor L1209 motor for use in a synchronous
> rotary spark gap. 
 
> Any help on this subject would be greatly appreciated.  I don't run want to
> run the spark gap async, as I don't have an infinite number of NSTs to feed
> it.
 
> Bwaa-haa-haa,
 
> I, Arc >>

Aric,

The space between the dead poles doesn't really matter.  If your
armature is about 3.3" diameter, then make the 4 flats each about
1 1/16" wide, and it will work fine if it's typical induction motor.

John Freau

• Prev: Re: [FAQ]
• Next: Re: ATTN. - Site Online (properly at last) (fwd)
• Index(es):
  • Main
  • Thread