Re: Secondary Wire Type

To: tesla-at-pupman-dot-com
Subject: Re: Secondary Wire Type
From: "Dr. Resonance" <Dr.Resonance-at-next-wave-dot-net> (by way of Terry Fritz <twftesla-at-uswest-dot-net>)
Date: Tue, 11 May 1999 16:11:21 -0600
Approved: twftesla-at-uswest-dot-net
Delivered-To: fixup-tesla-at-pupman-dot-com-at-fixme

to: Adam

200 degree C is the best type wire to use for this application.  Also,
Beldon Polythermalize is also great.

Regards,

Dr.Resonance


-----Original Message-----
From: Tesla List <tesla-at-pupman-dot-com>
To: tesla-at-pupman-dot-com <tesla-at-pupman-dot-com>
Date: Tuesday, May 11, 1999 3:14 AM
Subject: Secondary Wire Type


Original Poster: "aspid" <aspid-at-netzero-dot-net>

I'm planning on building a 4.25" x 18" secondary using AWG24. It will be
powered by a 15kv, 30 ma NST, which may get parelleled in the future. I
found some wire with the following specs: "An enamel coating gives this wire
good moisture and heat resistance, so it can be used in hermetic motors.
Wire meets NEMA 1000 MW-73 and MW-35, and is rated at 7,500 VAC. Temperature
rating 200° C." Is this OK?


thanx

Adam Minchey
aspid-at-netzero-dot-net
ICQ 9397016

________________________________________________________
NetZero - We believe in a FREE Internet.  Shouldn't you?
Get your FREE Internet Access and Email at
http://www-dot-netzero-dot-net/download/index.html