[Prev][Next][Index][Thread]

Re: Several Questions

Hi Adam,

At 02:01 PM 12/30/1999 -0800, you wrote:
>I have some copper ribbon which is 1" wide by ~.005"
>thick. It was shielding for some scrap cable I found.
>Is this of any use for interconnects? What about for
>the RF ground? If not, what thickness should I shoot
>for? I can't find any local copper flashing so
>McMaster Carr or MSC is where I'll probably go. Do I
>need OFC? BTW, I'll probably be at 15 kV, and <1kVA
>for a while.

That strap is fine for around 1KVA use.  If in doubt, just double them up.

>
>I'm getting ready to build an MMC and have searched
>locally and on the web for perfboard. I found several
>sites selling phenolic perfboard, but haven't had much
>luck finding G10. Is there a difference, and if G10 is
>desirable, where is a good source in the US. I'm
>looking for a single board ~12" x 12", but could
>probably settle for two boards ~6" x 12".

I like the Epoxy Glass perfboard because I know it is high quality and will
not fail me or my caps.  Digi-key sells it in all varieties.

http://www.digikey-dot-com/EC/V3/496.pdf

I get V1011-ND myself...  8.5x17 at $19.95

Cheers,

	Terry

>
>thanks
>Adam Minchey
>yurtle_t-at-yahoo-dot-com
>__________________________________________________
>Do You Yahoo!?
>Talk to your friends online with Yahoo! Messenger.
>http://messenger.yahoo-dot-com
>