[Prev][Next][Index][Thread]
WinTesla Ver 2.0
----------
From: Pete [SMTP:casius-at-cyberserv.co.za]
Sent: Thursday, May 28, 1998 1:30 PM
To: Tesla List
Subject: Re: WinTesla Ver 2.0
Hi Scott,
Have not seen your WinTesla software. Can't comment. If you are interested in a
schematic that really works with either a 811 or 812, give me a buzz.
Pete
Tesla List wrote:
> ----------
> From: Rscopper-at-aol-dot-com [SMTP:Rscopper-at-aol-dot-com]
> Sent: Wednesday, May 27, 1998 7:00 PM
> To: tesla-at-pupman-dot-com
> Subject: WinTesla Ver 2.0
>
> To all who use WinTesla,
>
> In an attempt to further my programming knowledge and contribute to the
> experimenters with ozone fever, I am working on WinTesla Ver 2.0 using
> Microsoft Visual C++ 5.0. Version 1.0 was built using Borland Delphi Pascal.
> I am planning to add a edit box for adding comments on a design, and some
> other user donated enhancement ideas I've been collecting for the past few
> months.
>
> I haven't had too many comments (good or bad) about the program this far, and
> I would like to know what you think about the program, and what improvements
> are needed. Send me a note at rscopper-at-aol-dot-com with your comments and
> suggestions.
>
> If I don't receive any comments, I will assume this project should be
> cancelled and the current product is acceptable.
>
> BTW I purchased an 811A and a 572B at Dayton, and am in the process of
> building a tube coil for grins. So far I have some hot glowing tubes, but no
> sparks yet - tuning isn't easy.........
>
> Scott