[Prev][Next][Index][Thread]
8KV tank supply from microwave oven components (fwd)
---------- Forwarded message ----------
Date: Tue, 19 May 1998 08:42:57 +0300
From: Marco Denicolai <marco-at-vistacom.fi>
To: tesla-at-pupman-dot-com
Subject: 8KV tank supply from microwave oven components
Because attached files are not forwarded, here is an ASCII drawing of my
tentative power supply. It is made of 2 sets of transformer + diode +
capacitor from two microwave ovens. The transformers give about 2KV, which is
doubled with capacitor + diode to 4KV. Put two of these is series and you
get 8KV. See the picture below:
| |
--------|| ||-----| |----*---------- -
* || || * | | |
|| || -----
220V || || \ /
|| || \ /
|| || -----
|| || |
--------|| ||------------*--- GND
|
|
--------|| ||------------*
* || || * |
|| || -----
|| || \ /
220V || || \ /
|| || -----
|| || | | |
--------|| ||-----| |----*----------- +
| |
If you are carefull with transformer phasing, you get 8KV pulses at
25 Hz (Europe = 50Hz 220V!). Connect the phases wrong and you'll get
4KV pulses at 50 Hz. Between + and - terminals I can get a 0.37" continuous
spark between a simple 2-screw gap.
Any problem to feed a TC with this (forget about filtering for now)?
________________________________________________________________________
Marco Denicolai Vista Communication Instruments, Inc.
Hardware Development Manager www.vistacom.fi
marco-at-vistacom.fi Kaisaniemenkatu 13 A
fax: +358-9-622-5610 SF-00100 HELSINKI
phone: +358-9-622-623-15 Finland
Remember, Murphy was an optimist! I am not...
________________________________________________________________________