[Prev][Next][Index][Thread]
Rotary Spark Gap Design Brainstorming
Subject: Rotary Spark Gap Design Brainstorming
Date: Mon, 21 Apr 1997 17:03:29 +0000
From: Chris Gardner <gchristo-at-clt.mindspring-dot-com>
To: Tesla List <tesla-at-pupman-dot-com>
References:
1
Though I havetn't actually made one of these things yet Ive been trying
to think of optimal designs.
These are some thoughts that I have had that I havent seen before or
heard of from anyone on this list yet so I thought I would throw them
out there for general consumption and feedback;
a - turbulent air flow over the points seems to be an advantageous
thing, why not alternate non conductive fins or vanes with the points on
the rotor such that after each point fires the atmosphere in the
immediate vicinity is forcibly disturbed.
this then led to
b - possibly even better, yet more difficult to construct, a sandwich
rotor, something like a vented disk brake. each side of the rotor would
have a smaller diameter plate attached to it by radiating vanes. the
inner diameter of this sandwiched plate would be larger than the axle,
allowing for intake.
this would be like sandwiching a rotary spark gap and two centrifugal
fans. Each contact on the rotor could be alloted its own 'jet' so that
it was constantly being cooled. And the stationary points would have a
constant blower accross them as well. Thus the 'blower' operation would
be instrinsic to the operation of the rsg.
I hope i described this well enough that you can see it without
drawings.
any thoughts? Has this been tried?