glass laminate - Bah, Humbug...

To: tesla-at-poodle.pupman-dot-com
Subject: glass laminate - Bah, Humbug...
From: Tesla List <tesla-at-stic-dot-net>
Date: Tue, 01 Apr 1997 22:44:37 -0600
Approved: tesla-at-stic-dot-net

Subject: 
        glass laminate - Bah, Humbug...
  Date: 
        Tue, 01 Apr 1997 20:43:53 -0500
  From: 
        "Daryl P. Dacko" <mycrump-at-cris-dot-com>
    To: 
        Tesla List <tesla-at-pupman-dot-com>

I've about given up trying to find a supplier of glass laminate
that will sell less than a 4'x8' sheet, or require a morgage on 
the house for a smaller piece. ;'{

I'm thinking about trying a 'hot' rotor design, using a ten inch
in diameter, one inch thick aluminum plate, mounted on bearings 
attached to some one inch thick lexan supports. 

I'm planning to use some thick walled rubber hose with a plastic
rod in the center as an insulated flexable coupling.

Does anyone have any experience with this type of design ?

Does anyone know of suppliers for laminate that are fairly 
inexpensive ?

Does anyone have a cure for "Tesla Fever" ?

Daryl