[Home][2015 Index] Re: [TCML] tube toploads [Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [TCML] tube toploads



this is an interesting thread!

i have to build my own in a few week! For calculating the final capacitance
i can use the same formula of solid one? right?

2015-01-15 16:04 GMT+01:00 Jim Lux <jimlux@xxxxxxxxxxxxx>:

> On 1/15/15 6:20 AM, Tuomas Koivurova wrote:
>
>> I went for 1.5x tube diameter spacing (from side to side) and it works ok.
>> I do get stray streamers at extreme power levels but that is to be
>> expected.
>>
>
> so, for a 1cm tube, there would be 1.5cm between tubes (the tubes are
> 2.5cm center to center)?
>
> That's similar to the "spacing = circumference" that I use when modeling
> structures and antennas in NEC.
>
>
>
>
>  On 15 Jan 2015 16:15, "Jim Lux" <jimlux@xxxxxxxxxxxxx> wrote:
>>
>>  Anyone have any design guidelines for top load toroids made of tubes
>>> (like
>>> Greg's picture in the recent post on 150kVA SGTC thread).
>>>
>>> Is there some rule of thumb like "spacing between the tubes should be the
>>> tube diameter or circumference"..
>>> _______________________________________________
>>> Tesla mailing list
>>> Tesla@xxxxxxxxxx
>>> http://www.pupman.com/mailman/listinfo/tesla
>>>
>>>  _______________________________________________
>> Tesla mailing list
>> Tesla@xxxxxxxxxx
>> http://www.pupman.com/mailman/listinfo/tesla
>>
>>
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxx
> http://www.pupman.com/mailman/listinfo/tesla
>
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla