Re: Inert gas SG

["Metlicka Marc" <mystuffs-at-orwell-dot-net> (by way of Terry Fritz <twftesla-at-uswest-dot-net>)]

Tesla list wrote:

> Original poster: "Jason Johnson" <hvjjohnson13-at-hotmail-dot-com>
>
> I reread the original post and there is no mention of a rotary just a spark
> gap. No R just SG.

i'm sorry jason, i must have automatically put the rotary in the spark gap? i
think i'm loosing it so except the apology's? a static gap done this way sounds
like a very good experiment, i would be interested in the results if you or
anyone tries this.
marc

>
>
> Sorry to nitpick
> Jason Johnson
>
> ----- Original Message -----
> From: Tesla list <tesla-at-pupman-dot-com>
> To: <tesla-at-pupman-dot-com>
> Sent: Thursday, September 14, 2000 7:30 AM
> Subject: Re: Inert gas SG
>
> > Original poster: "Metlicka Marc" <mystuffs-at-orwell-dot-net>
> >
> > jason,
> > i think the spinning rotor would create a vortex inside the box and pull
> > fresh air in through the slots?
> > just my opinion though. on the other hand, since plastic holds a great
> > amount of heat for a very long time, this property could be used as an
> > advantage. epoxy peltier on the plexy and let it cool a short while,
> > then fire the gap. the plexy will suck up the heat and the peltiers will
> > sink it away. quite expensive but possible
> > marc
> >
> >
> >
> >