Re: Comercial Toroids

["Roderick Maxwell" <maxz-at-netdoor-dot-com> (by way of Terry Fritz <twftesla-at-uswest-dot-net>)]

----- Original Message -----
From: Tesla list <tesla-at-pupman-dot-com>
To: <tesla-at-pupman-dot-com>
Sent: Thursday, September 07, 2000 9:04 AM
Subject: Re: Comercial Toroids


> Original poster: FutureT-at-aol-dot-com
>
> In a message dated 9/6/00 7:15:43 PM Pacific Daylight Time,
tesla-at-pupman-dot-com
> writes:
>
> > Original poster: "Luc" <ludev-at-videotron.ca>
> >
> >  Hi Max
> >
> >  John freau member of this list make toroids, you could see it on his
site.
> >
> >  Luc Benard
>
> Max, Luc, all,
>
> I've discontinued my toroid operations (too much time and work).
> The only ones I still have available are the small 1.5" by 6" spun
> aluminum toroids in either brushed or spin-polished finish.  These
> are $36 postpaid.  ($36 is the total cost, I pay the postage within
> the USA).
>
> John Freau
> 49 Thiem Ave
> Rochelle Pk, NJ   07662
>
>    http://hometown.aol-dot-com/futuret/page3.html
>
>

    Too bad. It seems you are doing a nice job of it!  The toruses that you
have available are to small for my needs in any case.
The secondary that I want a torus for is 9.75" in diameter.

      Frankensteins Helper
                 Max
>