Re: Fw: Polypropylene coil form

["Luc" <ludev-at-videotron.ca> (by way of Terry Fritz <twftesla-at-uswest-dot-net>)]

Tx Kennan

I remember your posting My concern is how the glue on the double side tape
will age.

By the way I check your patent and I almost can't wait for you complete
schematic.

Luc Benard


Tesla list wrote:

> Original poster: "Kennan C Herrick" <kcha1-at-juno-dot-com>
>
> Luc-
>
> See my "recipe" postings of 8/19 & 8/20 for how I made a secondary.  I
> recommend 2-side "sticky-tape" for holding the wire in place prior to
> varnishing it. I would think that would stick to polypropylene--at least
> long enough & well enough to hold the wire.  If not, perhaps you could
> rough-up the poly with sandpaper to give a "tooth" for the tape.
>
> Ken Herrick
>
> --------- Forwarded message ----------
> From: "Tesla list" <tesla-at-pupman-dot-com>
> To: tesla-at-pupman-dot-com
> Date: Sun, 03 Sep 2000 16:59:05 -0600
> Subject: Polypropylene coil form
> Message-ID: <4.1.20000903165903.009f7f00-at-pop.dnvr.uswest-dot-net>
>
> Original poster: "Luc" <ludev-at-videotron.ca>
>
> <snipped>
>
> I have 2 nice piece of 4.5" polypropylene pipe, I want to make coils
> with them .
>
> <snipped>
>
> Do you have advice ?
>
> Tx
> Luc Benard
>
> ________________________________________________________________
> YOU'RE PAYING TOO MUCH FOR THE INTERNET!
> Juno now offers FREE Internet Access!
> Try it today - there's no risk!  For your FREE software, visit:
> http://dl.www.juno-dot-com/get/tagj.