Fw:

• To: tesla-at-pupman-dot-com
• Subject: Fw:
• From: jkooi-at-wish-dot-net (by way of Terry Fritz <twftesla-at-uswest-dot-net>)
• Date: Sat, 06 May 2000 12:33:38 -0600
• Approved: twftesla-at-uswest-dot-net
• Delivered-To: fixup-tesla-at-pupman-dot-com-at-fixme

hi terry or chip,

I keep getting mails, originating from <tesla-request-at-pupman-dot-com> instead of
tesla list

greetings from jeroen. from holland

>> I have noticed these too.  I'll ask Chip about it.  May be related to
the server problems this week - Terry <<<


----- Original Message -----
From: <tesla-request-at-pupman-dot-com>
Sent: Saturday, May 06, 2000 1:17 PM


> In a message dated 5/5/2000 8:42:34 PM Mountain Daylight Time,
> tesla-at-pupman-dot-com writes:
>
> >
> >  Original Poster: Terry Fritz <twftesla-at-uswest-dot-net>
> >
> >  Hi Dan,
> >
> >   Each cap would then have to be 0.04 uf.  When you put them in series,
as
> >  in equidrive, you get back to 0.02uF again.  "I" can't think of any
reason
> >  equidrive whould have an advantage but let us know if you notice
> anything...
> >
> >  Cheers,
> >
> >   Terry
> >
> The only possible advantage that I can think of is that corona generation
> could be reduced a little by "spreading" out the charge.  My new
transformer
> produces 22kV, so there might be a reason to use this for the higher
voltage.
>   My coil is set up with this configuration, but I see no advantage to it
as
> far as the tank circuit operation.  I do like the symmetry though :o)
> Mike
>
>

• Prev: Re: Flat Ribbon Conductors
• Next: Re: Commercial cap specs for tesla cap
• Index(es):
  • Main
  • Thread