Re: Out of round PVC

• To: "Tesla List" <tesla-at-pupman-dot-com>
• Subject: Re: Out of round PVC
• From: "Ruud de Graaf" <rdegraaf-at-daxis.nl>
• Date: Thu, 4 May 2000 00:17:59 +0200
• References: <4.1.20000502164917.009fedf0-at-pop.dnvr.uswest-dot-net>

> Original Poster: "Bob Berg" <berg_bob-at-hotmail-dot-com>
>
> I just bought a 10 ft length of 6" PVC Drain pipe to  wind my new
seconday.
> the way the PVC was strap in the bundle its a little out of round,
somewhat
> oval like.  Does anyone know of a way to make it round again?
> Thanks
> Bob
> ________________________________________________________________________

Hi Bob,

You could try to warm it up on the distorted place with a paint heater or
hair dryer. I repaired my plastic car bumbers? (collision protection in
front and on the back) that way. Be careful not to overheat the PVC or it
will burn! Always move the heather.

Greetings from Holland,

Ruud de Graaf

• Out of round PVC
• From: "Bob Berg" <berg_bob-at-hotmail-dot-com> (by way of Terry Fritz <twftesla-at-uswest-dot-net>)

• Prev: Re: MASSIVE Coil
• Next: Re: Beginner Questions about Core and Bobbin
• Index(es):
  • Main
  • Thread