[Prev][Next][Index][Thread]
Re: Grinding sync motors with an angle grinder :-))
-
To: tesla@pupman.com
-
Subject: Re: Grinding sync motors with an angle grinder :-))
-
From: "Jim Lux" <jimlux@earthlink.net> (by way of Terry Fritz <twftesla@uswest.net>)
-
Date: Sat, 20 May 2000 16:58:58 -0600
-
Approved: twftesla@uswest.net
-
Delivered-To: fixup-tesla@pupman.com@fixme
----------
> From: Tesla List <tesla@pupman.com>
> To: tesla@pupman.com
> Subject: Re: Grinding sync motors with an angle grinder :-))
> Date: Saturday, May 20, 2000 9:54 PM
>
> Original Poster: "Robert Jones" <alwynj48@earthlink.net>
>
> Hi all,
>
>
> >Original Poster: "Jim Lux" <jimlux@earthlink.net>
> >
> >>
> >> My rotor is 3.2226 inches across. I am cutting flats 0.850 wide. My
1/4
> >> HP A.O. Smith motor has 36 metal chunks in the outer motor part (not
the
> >> rotor).
> >
> >That's called the field..
>
> Where I come from its called the stator.
That too..