RE: Polypropylena caps

["Ted Rosenberg" <Ted.Rosenberg-at-radioshack-dot-com> (by way of Terry Fritz <twftesla-at-uswest-dot-net>)]

Hi jeremiah:
as I may have mentioned, I used Seacor caps from Dave McKinnon(D&M High
Voltage). The specs on those caps can be found at:

http://www.seacorinc-dot-com/Tables/specs/KP25/default.htm

I think I posted a photo of my finished MMC too.
Now if I can just finish the primary and mount it over the w/e I might get
my coil going in the next few days.

Safety to ya!

Ted Rosenberg
Geek Group Member #55
www.thegeekgroup-dot-org
Because the Geek shall inherit the Earth!

uuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuu

Subject: Polypropylena caps

Original poster: "Jeremiah" <jmeizis-at-metallicafan-dot-com> 

Hey,  what are the characteristics of the polypropylene capacitors used in
mmc's in tesla coil use.  Like low inductivity, low dissipation factor and
such.  i looked on the digikey website and i didn't see any but i didn't
look all that good so i'll probably go back.
Thanks
Jeremiah

_____________________________________________
Free email with personality! Over 200 domains!
http://www.MyOwnEmail-dot-com