[Home][2020 Index]
Thank you very much for this Gary, I missed the part about being a SRSG! Good call! Matt Lewis, Fairlee VT -----Original Message----- From: Gary Lau <glau1024@xxxxxxxxx> To: Tesla Coil Mailing List <tesla@xxxxxxxxxx> Sent: Sun, Sep 27, 2020 8:28 pm Subject: Re: [TCML] Is this still correct, javatc Assuming you have 60Hz power, for a 15/120 NST power source, a .031uF cap is correct if you are using a static gap, but for a SRSG, you need a much larger value. I think .055uF is about right. There is great danger if you use too small a cap with a SRSG, it will charge to a voltage far in excess of the NST rating, endangering both the NST and cap. I can't emphasize this too strongly - having a PROPERLY SET safety gap in parallel with the SRSG is mandatory. If your safety gap insists on firing, it may mean that your cap isn't large enough (resonance issues aside). Regards, Gary Lau MA, USA On Sun, Sep 27, 2020 at 8:00 PM shaun <snoggle@xxxxxxxxxxxxxx> wrote: > With javatc I noticed that it recommend a 55nf primary cap for use in a > srsg, 4 neon 15000/30 system. But after loads of reading I have not seen > any > one actually use this value or even close to this. Seems most say .031 or > something close. Is javatc recommendation of 55nf alright to use or just a > ball park. Thanks > > _______________________________________________ > Tesla mailing list > Tesla@xxxxxxxxxxxxxxxxxx > https://www.pupman.com/mailman/listinfo/tesla > _______________________________________________ Tesla mailing list Tesla@xxxxxxxxxxxxxxxxxx https://www.pupman.com/mailman/listinfo/tesla _______________________________________________ Tesla mailing list Tesla@xxxxxxxxxxxxxxxxxx https://www.pupman.com/mailman/listinfo/tesla