Thread-topic: Acrylic sheet for primary coil insulator
My coil is probably considered to be on the larger side. It is 8.6" in diameter and uses a 3600 RPM RSG with protection gap. It is powered by a pole transformer and at 4.8 KVA it produces 8 foot streamers. I do have a strike rail. The vast majority of the time, the strike rail absorbs the errant streamers. On occasion, however, a streamer will strike the primary coil. In one instance, after striking the primary, the streamer then jumped over to the secondary coil. Although no damage was observed, I certainly don't like the idea of streamers striking the delicate secondary coil. So this is my motivation for considering the acrylic sheet. I wouldn't even consider this if I had to buy the acrylic. I got it for nothing.
Is there anyone that has tried covering the primary coil with an insulating sheet such as acrylic or something else? If so, did it help?
Steve White
Cedar Rapids, Iowa
----- Original Message -----
From: "Gregory Peters" <greg.j.peters@xxxxxxxxx>
To: "Tesla Coil Mailing List" <tesla@xxxxxxxxxx>
Sent: Sunday, September 2, 2018 4:57:31 PM
Subject: Re: [TCML] Acrylic sheet for primary coil insulator
Personally I would only use the acrylic if you want to stop people from touching the primary - which is normally only an issue on small coils that people actually have the guts to get close to.
The strike rail will do a great job of preventing primary strikes on it's own. Just be sure to leave half to one inch gap in it to prevent it from acting like a shorted turn. Save that nice sheet for something more useful.
If it's a regular SGTC a properly made safety gap with a grounded centre post may also help prevent damage from an inadvertent primary strike, but really in 20 years of coiling and quite a few coils I have never seen the coil arc past the strike rail to the primary.
Cheers!
Greg.
-------- Original message --------From: Steve White <steve.white1@xxxxxxxxx> Date: 3/9/18 1:50 am (GMT+10:00) To: Tesla Coil List <tesla@xxxxxxxxxx> Subject: [TCML] Acrylic sheet for primary coil insulator
I am considering adding an acrylic sheet as a top cover for my primary coil to minimize primary strikes. I never would have considered such a thing because of the expense but I recently acquired a large sheet of 5/16" acrylic sheet for nothing, so that idea has now returned. My question concerns the strike rail. Should I install one with this cover or not? Here are my options as I see them:
1. No strike rail
2. Strike rail in the normal position on top of the acrylic sheet
3. Strike rail under the acrylic sheet
My concern with number 1 and 3 is that if a streamer finds its way around and under the acrylic sheet, the streamer may melt or burn a portion of the acrylic. I have heard of at least one coiler that has installed such an acrylic sheet and I recall that he placed the strike rail under the sheet. I forgot the link.
Steve White
Cedar Rapids, Iowa
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxxxxxx
https://www.pupman.com/mailman/listinfo/tesla
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxxxxxx
https://www.pupman.com/mailman/listinfo/tesla
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxxxxxx
https://www.pupman.com/mailman/listinfo/tesla