I can't comment on your GF working in a TC. I've not personally tried it,
but the prevailing wisdom is that it typically doesn't work in a TC
application. I wonder if higher voltage GF NST's are more affected than
lower voltage ones?
The resistors - 1KOhm, 25Watt, 210-what? What are these for? It sounds
like they're intended to be part of a protection network, except that
resistors must be used with capacitors to form a low-pass filter network.
By themselves or with safety gaps, resistors serve no protective purpose.
Regards, Gary Lau
MA, USA
On Thu, Nov 29, 2018 at 6:22 PM Douglas Johnson <doug379306@xxxxxxxxx>
wrote:
I had a 6K GF NST laying around and decided to see if I could use it on a
small TC. I ran a 1K 25w210 wire wound resistor between each leg of the
NST
and the safety gap, it worked just fine. I switched the GF 6kv NST with a
non GF 6kv nst and the coil output was identical.
I was always told that a GF NST would not work for a TC??
Resistors are holding up ok.
Comments please
Doug
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxxxxxx
https://www.pupman.com/mailman/listinfo/tesla
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxxxxxx
https://www.pupman.com/mailman/listinfo/tesla