Depending on the design we use 1/8" or 1/4" Lexan for our MMCs.
Interconnect wires for our stuff is usually 14AWG or so.
On Sat, Jun 23, 2018 at 12:45 PM, James Janota <j.janota@xxxxxxxxxx> wrote:
> I have 24 942c6p15kf each with their own 0.5 watt 10Mohms resistor. I hope
> that’s enough. So the question becomes mounting them. How thick of
> plexiglass should suffice? What gauge wire should I use to connect the NST
> and the primary?
>
> Regards
>
> James Janota
> (727)512-7112 Phone
> (727)595-6625 Fax
>
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxxxxxxxxxx
> https://www.pupman.com/mailman/listinfo/tesla
>
--
Chris Boden
President
The Geek Group National Science Institute
www.thegeekgroup.org
--
This email may contain confidential and privileged material for the sole
use of the intended recipient. Any review or distribution by others is
strictly prohibited. If you are not the intended recipient please contact
the sender and delete all copies.
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxxxxxx
https://www.pupman.com/mailman/listinfo/tesla