Is there a clear advantage in using the DC resonant charging approach
versus just using the MOT's AC output? It would use far less components
that way, seems quite simpler.
On Thu, Dec 22, 2016 at 6:13 AM, TESLA <tesla@xxxxxxxxxxxxxxx> wrote:
> Hi Martin
>
> I built a really high power tesla from MOT s (14 in the whole machine)
>
> * That was 6 MOT's in primary centre ground 3 per side (shunts removed)
> input load shared by separate power to each half of the 6 MOT's
> * Considerable PFC was used and NO other ballasting was needed (drew 50a
> or so from my 230v supply at full bore)
> * Outer MOT's in xfrmr oil (no mains eths used, some like to apply that I
> recommend swamping capacitance between core and secondary and core and
> primary to equalise stress if floating core
> * FW bridge of 3A 1kV diodes (just lots and lots used overkill and no
> equalising components)
> * DC Pi filter of 2uF caps and 10mH MOT arrage (gapped MOT's of 0.3mm
> array of 4 , 2 in series then parallel two of those)
> * Ring up inductor another array of 4 gapped MOT's (parallel two sets of
> 2 in series)
> * DQ of about 50 1n4007
> * Bleeders on ALL Caps (several independent chains in case one chain went
> open)
> * 90nF Cp (Used CDC 942C series 942C16P33K, for big coils these are
> better value than the so called Geek group ones
> * 300bps rotary SG (was sync but need not have been)
> * Big secondary and large topload (8" and also a 12" at times and 300mm
> x1.1m top)
>
> That beast did well over 10kVA and over 3.5m arcs, it is perhaps a little
> ambitious but makes good use of very cheap components,unsafe in the hands
> of untrained users, I recently gave it to an enthusiast with better
> location to use it. Needs a dedicated supply (spa pol in my case, all
> stoves and water heaters switched off when it was running to keep pole fuse
> intact.)
>
> Good luck tedl in NZ
>
> -----Original Message----- From: Martin Slinning
> Sent: Thursday, December 22, 2016 5:15 AM
> To: tesla@xxxxxxxxxx
> Subject: [TCML] Tesla coil setup using MOT
>
>
> Hi.
> My students and i have just finished building av flyback/zvs coil and want
> to step up to a New coil using MOTs. We have seen different setups but we
> are looking for tips on how to build the most effective coil. In Norway we
> have limited access to NST, but MOTs are no problem. We have now about 11
> mots and a bunch of MO caps and diodes.
> We are planning on making av rsg using av 2800 rpm motor and an inverter
> to raise to 150-200 Hz to get whatever rpm we need.
> Anyone who can give us tips on what to do, and not do, are greatly
> appreciated.
>
> Best regards
> Martin Slinning.
> (Teacher Electric automation at Norwegian highschool.)
>
>
> Sendt fra min iPhone
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxx
> http://www.pupman.com/mailman/listinfo/tesla
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxx
> http://www.pupman.com/mailman/listinfo/tesla
>
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla