I wonder - take two large sheet metal washers. Weld together inside and out
. Add a zerk fitting. Use a grease gun to pressurize. It will certainly
form something somewhat torroidial, I would think.
-----Original Message-----
From: Tesla [mailto:tesla-bounces@xxxxxxxxxx] On Behalf Of Finn Hammer
Sent: Tuesday, September 15, 2015 10:09 AM
To: Tesla Coil Mailing List <tesla@xxxxxxxxxx>
Subject: Re: [TCML] Hydroforming Toroids
Dave, all:
Jamie is doing a remarkably fine job for an amateur, with the surf board,
and this is because the finished object has a shallow angle at the edge.
Raising a sheet metal object up to 30 degrees is not so difficult, but
acheiving a 90 degrees edge angle will prove impossible, without blowing the
part into a negative mold.
This is at least what this toolmaker thinks, and why he still has his
toroids made at the local metal spinning shop.
Cheers, Finn Hammer
----- Original meddelelse -----
> Fra: Dave Leddon <dave@xxxxxxxxxx>
> Til: Tesla Coil Mailing List <tesla@xxxxxxxxxx>
> Dato: Man, 14. sep 2015 05:10
> Emne: [TCML] Hydroforming Toroids
>
> The other day I was watching an episode of Mythbusters in which Jamie
> used hydroforming to fabricate a pontoon out of stainless steel.
> (Sorry I could only find this in Spanish)
> https://www.youtube.com/watch?v=sxcOzPzqOi8
> Is there any reason that we couldn't use the same technique to create
> toroids? It would seem that all one would need is three thick pieces
> of steel plate, a large outer ring, a small inner disk and a large
> bottom disk. A pressure washer would provide the necessary high
> pressure water. What do you think?
>
> Dave
>
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxx
> http://www.pupman.com/mailman/listinfo/tesla
Mvh. Finn Hammer
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla