From the top of my head I can only say
that the MKP will not work reliably.
FKP1 would be the correct choice from Wima,
e.g the 100nF 100V or 1600 V DC
regards
Christoph
> Hello people
>
> This is my first post on the mailing list. I'm actually working on a Spark
> gap tesla Coil, and am stuck at making a choice as to which capacitor
> should be used for making the MMC.
> I have gone through the list of Good and Bad Capacitors compiled on the
> mailing list and many other sites, but these ones haven't been listed
> anywhere. If anyone of you have previously worked with the below mentioned
> capacitors, or can provide any information about the reliability of these
> capacitors in an MMC, it will be really helpful.
>
> 1. WIMA MKP10 series 47nF 1kV
> Mfr Part#: MKP1O124704F00KSSD
> http://goo.gl/ISMpzu
> dV/dt ; 2700
>
> 2. Panasonic ECW-HA3C473J
> 47nF 1.6kV
> http://goo.gl/yWDkUS
> dV/dt ; 2000
>
> 3. EPCOS B32653A1223K
> 22nF 1.6kV
> http://goo.gl/cFjyr2
> dV/dt : 2400
>
> 4. Vishay MKP1841347135
> 47nF 1.6kV
> http://goo.gl/vIMwX8
> dV/dt : 2680
>
> These are the few good options that I found suitable for my requirements.
> Any other economical and similar suggestions are also welcome.
> Thanks
>
> Ayush Sharma
> ᐧ
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxx
> http://www.pupman.com/mailman/listinfo/tesla
>
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla