Sorry in advance if this question is too basic, however...
Is there a latest, best way of terminating the LV winding end at the bottom
of the secondary?
So far, I soldered the winding end to the back of a curved copper strip
1/2" x 1 1/2" located halfway between the first turn and the bottom of the
coil form. The strip/wire was then epoxied to the form.
Any suggestions as to the best way to make the final connection to RF
ground. I did not want to start making holes in the base before having a
plan, for once.
Thank you in advance for any suggestions.
Tim Flood
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla