Re: [TCML] Flywheel Pulley on Treadmill Motor

[Futuret <futuret@xxxxxxx>]

David,

My guess is that it's left-hand thread, based on the CW rotation.  

John

 

 

 

-----Original Message-----
From: David Rieben <drieben@xxxxxxx>
To: Tesla Coil Mailing List <tesla@xxxxxxxxxx>
Sent: Thu, Aug 1, 2013 8:31 am
Subject: Re: [TCML] Flywheel Pulley on Treadmill Motor


Hi Adam, all,
 
The next question is are the threads on the shaft left-hand or standard 
right-hand thread? The shaft
turns CW as you face the motor from the flywheel end of it (the shaft spins the 
same direction that
you would turn the flywheel to TIGHTEN it, IF it's a standard right-hand thread. 
I'm thinking that it
may be left-hand thread because my stick edger also turns the blade CW as you 
face the blade end
and the threaded shank and matching nut that hold it in place are left-hand 
threaded. Any suggestions
here also welcome.
 
David Rieben


 
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla