RE: [TCML] Pole transformer

["Joe Korick" <joekorick@xxxxxxxxxxx>]

Yep!
That was me. 

-----Original Message-----
From: tesla-bounces@xxxxxxxxxx [mailto:tesla-bounces@xxxxxxxxxx] On Behalf
Of Shelby L.
Sent: Monday, February 28, 2011 6:53 PM
To: Tesla Coil Mailing List
Subject: Re: [TCML] Pole transformer

By chance, did you buy this transformer from ebay?
Because I watched one exactly like that sell for around 100$.

On Thu, Feb 24, 2011 at 5:16 PM, Joe Korick <joekorick@xxxxxxxxxxx> wrote:

> I recently acquired a 10KVA pole transformer that has been removed 
> from its case.
> My plans are to build a suitable enclosure and fill it with oil to 
> immerse the transformer.
> My question has to do with the wiring of the transformer.
> It has 6 connection points.
> 4  copper straps, 2 large and 2 smaller on one side of the transformer.
> 2  smaller wire on the opposite side.
> Measuring the resistance, I have continuity from 1 large strap to one 
> of the smaller straps Same with the opposite set of straps. No 
> continuity from the large straps to each other.
> The smaller wires on the opposite side I assume are the high voltage 
> windings and I measure resistance across them.
> This is a 220 v transformer with 2 high voltage outputs 12 KV.
> Can anyone explain the low side wiring to me with the copper straps
>
> Joe
>
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxx
> http://www.pupman.com/mailman/listinfo/tesla
>



--
Shelby
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla

_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla