Re: [TCML] 6" coil form

["Peter Terren" <pterren@xxxxxxxxxxxx>]

Use the 6 inch threaded cap and attachment. Bolt the cap onto the base with 
nylon bolts. then your secondary just unscrews. The secondary wire feeds 
through a center hole.  Don't forget you may need a spacer to get the right 
height above the primary like an inch or two to the start of the secondary 
winding.

This means you can dismantle the coil easily and it is quite secure.

Peter
----- Original Message ----- 
From: <jhowson4@xxxxxxxxxxx>
To: "tesla list" <tesla@xxxxxxxxxx>
Sent: Saturday, June 25, 2011 10:14 AM
Subject: [TCML] 6" coil form


> Hello all,
>
> Does anyone have any suggestions on how to anchor a 6" PVC pipe to a base.
> Previously I have used toilet flanges for all my coils, but a 6" flange 
> appears to not exist and I am at a loss for ideas.
>
> Thanks,
> John "Jay" Howson IV
>
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxx
> http://www.pupman.com/mailman/listinfo/tesla


_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla