RE: [TCML] DRSSTC and targets to strike

[Justin B <boshjack@xxxxxxxxxxx>]

Hello steve, I recently tried it my self.  I put a grounded 24" x 24" grid about 25" from my DRSSTC and just let the thing rip.  My scope, unless it was induction interference, was showing I was running 800A.  I question if it was fake, induced fields from the primary.  With an induction setup, I made the OCD kill out at 700A. But the scope was showing full-view 800A.  Im sure it was due to fake inductance, but I'll invest.  Other than that, I did a decent run on a grounded object and things didnt blow up.  I included a video link below to my test, it went fine for my largest test yet, Was sure nice and loud for my first ever DRSSTC.  The primary was not tune at all, I just randomly stuck a tap in and powered it.

http://www.youtube.com/watch?v=AnIW3tzXcNk

Thanks for the help!

> Date: Wed, 20 Jul 2011 11:48:48 -0500
> Subject: Re: [TCML] DRSSTC and targets to strike
> From: steve.ward@xxxxxxxxx
> To: tesla@xxxxxxxxxx
> 
> Direct ground sparks are usually OK provided the target is not excessively
> close to the toroid, which presents more of a "short circuit" to the
> secondary and consequently, the primary.  The ground sparks will tend to
> make the primary current surge higher than normal.  Some people have
> reported that these ground arcs cause their power electronics to fail.  I
> personally have not had much problem with this.  I suspect if its not merely
> the increase in primary current, that maybe some noise is causing improper
> switching of the IGBTs, or maybe some other mechanism related to "Ground
> bounce".
> 
> Steve
> 
> On Tue, Jul 19, 2011 at 9:58 PM, Justin B <boshjack@xxxxxxxxxxx> wrote:
> 
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxx
> http://www.pupman.com/mailman/listinfo/tesla
 		 	   		  _______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla