[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [TCML] SRSG question
Steve,
In the past I've used a black light and fluorescent tape, it
makes seeing the pattern easier. I lined up the middle of the glowing
band to the electrodes, but results may vary from one fixture to
another, like John said trial and error is necessary, I never had
great luck with the SRSG, but my cap was way too small to use it
effectively...
Scott Bogard.
On 11/16/10, Futuret <futuret@xxxxxxx> wrote:
> Steve,
>
> I don't use the fluorescent to get the phase in the ball park. I use
> the fluorescent to verify that the circuit is working properly and that
> you can see the phase shifting on the rotor. The phase position is
> best found by trial and error. If you get best sparks near the end
> of the phase variac's knob range, then you'll need to shift the
> rotor on the motor shaft to "center" it in the phase shifter range
> (or rotate the motor in it's cradle which accomplishes the same
> thing). The reason trial and error is needed to find the best
> phase position is because there's delay in the timing of the
> firing, and the amount of delay depends on many factors.
> Only the old fluorescent bulbs work (ballast type), and some
> folks have great trouble seeing the shifting pattern as they
> turn the variac knob. Some folks use a neon bulb system
> instead of the fluorescent since it's easier to see the phase
> shift effect.
>
> Cheers,
> John
>
>
>
>
>
>
>
>
>
>
> -----Original Message-----
> From: Steve Vance <steve_vance@xxxxxxxxxxxxx>
> To: Tesla Coil Mailing List <tesla@xxxxxxxxxx>
> Sent: Tue, Nov 16, 2010 12:00 pm
> Subject: Re: [TCML] SRSG question
>
>
> Thanks Gary,
>
>
>
> I designed the coil with the addition of another NST in mind. The reason I
>
> didn't build it in it's final configuration Is because I like to tinker and
>
> change things up. I think I enjoy building as much as running them.
>
>
>
> I don't have an extra variac to build a phase controller right now. Seems
>
> like I remember something about using a fluorescent light to get the phase
>
> adjustment into the ballpark. I did a search but couldn't find anything.
>
> Does anyone know where I might find this info?
>
>
>
>
>
>
>
>
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxx
> http://www.pupman.com/mailman/listinfo/tesla
>
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla