RE: [TCML] Primary support "advance"

["Richard Schmuke" <rdj@xxxxxxxxxxxx>]

I agree with making them the same I just want to ad when I made mine I made
the supports too long then after I got them in place and mounting holes
drilled I trimmed the ends as the last step so the ID and OD were concentric
and the mounting slots were staggered.

Rich , KdØzz
My wife complains I mess with stuff too much but I have a "tinkering virus"

  

-----Original Message-----
From: tesla-bounces@xxxxxxxxxx [mailto:tesla-bounces@xxxxxxxxxx] On Behalf
Of Jon Danniken
Sent: Thursday, November 11, 2010 8:46 AM
To: Tesla Coil Mailing List
Subject: Re: [TCML] Primary support "advance"

jeremyee@xxxxxxxx wrote:
>> On my last set of primary supports made of plexiglass, I decided to
>> make the supports identical and then stagger each support farther
>> from the center as you go out. I think it is much easier to build
>> the supports identical. I hope this helps!

Thanks Jeremy, I think it will indeed be a lot easier to make then uniform 
this way.

Jon 

_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla
No virus found in this incoming message.
Checked by AVG - www.avg.com 
Version: 9.0.869 / Virus Database: 271.1.1/3249 - Release Date: 11/11/10
01:34:00

_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla