[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: [TCML] Cutting Garolite disk



I haven't been following this thread, but why not just use a standard fly cutter on a mill?  is this to make one or two, or do you need thousands?
 
> Date: Tue, 22 Jun 2010 23:19:41 -0400
> From: arobinson@xxxxxxxxxxxx
> To: tesla@xxxxxxxxxx
> Subject: Re: [TCML] Cutting Garolite disk
> 
> CNC shop, laser cutting shop, or if the those arnt available, just your 
> standard machine shop.
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxx
> http://www.pupman.com/mailman/listinfo/tesla
 		 	   		  _______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla