Re: [TCML] Safety gap

["Quarkster" <quarkster@xxxxxxx>]

But be advised that 99% of the hardware store "drawer pulls" are die-cast 
zinc, with an incredibly thin lacquered "brass finish". The will erode very 
quickly if they ever actually see an arc.

Regards,
Herr Zapp
----- Original Message ----- 
From: "DC Cox" <resonance@xxxxxxxxxxxx>
To: "Tesla Coil Mailing List" <tesla@xxxxxxxxxx>
Sent: Saturday, November 28, 2009 1:11 PM
Subject: Re: [TCML] Safety gap


> You can buy the brass spheres from McMaster-Carr Company.
>
> You can also get some acceptable ones used for drawer pull knobs.  Check
> your Home Depot store.
>
> Dr. Resonance
(snip) 

_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla