RE: [TCML] New Coil Questions

["Jim Mora" <wavetuner@xxxxxxxxx>]

As previously mentioned, the HV from the pig goes to the cap if you put your
gap across the transformer which is recommended. The 0v ground return comes
from the rf ground and the coil base and inner turn of the primary. Keep us
posted.
Jim Mora 

-----Original Message-----
From: tesla-bounces@xxxxxxxxxx [mailto:tesla-bounces@xxxxxxxxxx] On Behalf
Of Tyler Pauly
Sent: Wednesday, May 27, 2009 8:21 PM
To: Tesla Coil Mailing List
Subject: Re: [TCML] New Coil Questions


I have more questions on the following two.

> 7)  Can I wire an arc welder in series with my outlet leads to current
limit?  I would think so, but again, it doesn't hurt to ask.

Yes, a 225 amp stick welder with its 240 input leads in
series with the input leads to the pig can be used as a ballast.
Many people that go this route simply short the output welding
leads and use the amp selector switch for input current control.
However, as Scot has also already mentioned here, most arc
welders are made as cheaply as can be gotten away with and
typically have like a 20% duty cycle at their maximum setting.
I finally ended up making a homemade ballast from the core
of a defunct x-ray transformer. You would have to make sure
that your core has sufficient cross sectional area to handle the
power that you're looking to control, too. Others can comment
on formulae for this.


I've heard of people using a PVC pipe as a form to wind heavy wire around,
and sticking welding rods inside to form an inductive ballast.  This sounds
somewhat cheap and very easy, but will it work?  What could go wrong, what
should I take into account etc.?



> 8)  My pig only has 1 HV bushing, so should I just split the wiring I
attach to it to get 2 leads off of it to make the primary circuit?  Sorry
for the bad wording, I hope I get my question across.

I also use a "single eared" pig to drive my current big coil with
out any problems. I isolate the case "return" of the pig as RF
ground and do not allow it to be attached to mains ground so
that the nasty RF kickbacks don't end up on the metal
surfaces of my control panel and bite me. ;^0 "I" use
that high voltage rated x-ray cable to run the HV from my
pig to my tank circuit and hook the single output bushing of
the pig to the inner conductors of the cable and the outer tank
to the outer braiding of the cable. This cable is basically coaxi-
al cable on steroids and is generally rated at around 75 kVDC.


I'm a little confused on both responses to this question.  For your answer,
where do I get some of this cable?   And what is the second object I'm
connecting the cable to?  I'm not very familiar with the lingo used with
pigs.  
So does this cable have two insulated conductors inside?  If I were to use
normal cable with only one conductor, I would be connecting an end to the
bushing and the other end to.... what again?   =P

Thanks again! 

Tyler



      
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla

_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla