Re: [TCML] Still stuck at 36"

[DC Cox <resonance@xxxxxxxxxxxx>]

you can achieve additional gains by using chunks of 1/2 thick plywood to
elevate your sec, thus tuning for best k factor.

should gain 2-4" more unless you just happen to have it near perfect right
now.

Dr. Resonance

On Fri, Jan 30, 2009 at 11:01 AM, Bill Bohn <b.jbohn@xxxxxxxxxxx> wrote:

> Seems that the spark gap is a major part of my problem.I pulled the ¾
> copper
> pipes out. I then cut 2 rings of pipe, cut a section out so they would fit
> tight into
>
> The pipe electrodes. Now they are .060 thick wall tubes. When I put them
> into service the the result was amazing.The sputtering stopped and it had a
> smooth
>
> Buzzing tone.I also gained 2 more inches in spark.Would thicker electrodes
> be even better? Say ¼" thick wall?I am hoping to reach 50" at the end of
> all
> this.
>
> Now I am getting 46".I did install another transformer. I am now 7.5kv at
> 110ma in the tank.
>
> Thanks again!
>
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxxxxxx
> http://www.pupman.com/mailman/listinfo/tesla
>
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla