Hi Karl,
I think Gary's comments covered that aspect of setting
up the synch gap thoroughly. One thing that I would
like to add as well is that titanium does not a good
spark gap electrode make, assuming that you were in-
tending to use the titanimu rods as permanent flying
electrodes. Tungsten is the first metal of choice for
this purpose and pure copper would probably be
the second best choice for this purpose. Titanium
does have excellent mechnical properties but not
ideal thermal and electrical characteristics for this
purpose.
David Rieben
----- Original Message ----- From: "Karl Thorkildsen"
<karl.thorkildsen@xxxxxxxxxxxxx>
To: "Tesla Coil Mailing List" <tesla@xxxxxxxxxx>
Sent: Sunday, January 25, 2009 2:24 PM
Subject: Re: [TCML] Calibrating a sync spark gap
Here's some pics:
Scope showing the AC line, the trigger point is at the very left
edge of the screen. The upper trace is the current probe but the
pulse is too short to see at this timebase. In the second pic you
can kinda see that it's triggering on both peaks.
http://www.thorbass.com/images/Tesla/ssg/ssgScope1.jpg
http://www.thorbass.com/images/Tesla/ssg/ssgScope2.jpg
This is a shot of the bolt with the titanium rod through it. You
can just make out the set screw on the left side at the bottom of
the bolt head.
http://www.thorbass.com/images/Tesla/ssg/ssg3.jpg
Test setup...
http://www.thorbass.com/images/Tesla/ssg/ssg2.jpg
At 01:38 PM 1/25/2009, you wrote:
I'm in the process of building a synchronous spark gap. I have
modified a motor and built a rotor from G10. My electrodes are
mounted by drilling a hole the long way through a bolt, then
drilling a hole sideways into the head and tapping for a set
screw. The bolts are mounted through the G10 with some washers as
cooling fins, and titanium rods stuck through held in place with
the set screws. I'll upload some pictures later and link to them.
The problem is how to set the position correctly. Here's what I did:
Hook up an NST to the gap and connect one channel of my scope to
the AC line of the NST (actually going through a variac too). I
took a piece of hookup wire, alligator clips on the ends, and
wrapped it around one of the output wires of the NST, about 5
wraps. The ends of this wire go across the other channel of the
scope, signal to gnd. Basically I built a cheap current probe.
Now firing the thing up, I set the scope to trigger on the current
probe. Basically getting a pulse every time the gap lines up. And
looked at the position of the AC line voltage relative to the pulse.
Using this method I got a fairly consistent display on the scope
and was able to adjust the position by rotating the motor in the mount.
Question, I think I remember reading that I should sync to about
85% of peak. In other words it should fire a little early, is that right?
- Karl
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla