Re: [TCML] SSTC

[DC Cox <resonance@xxxxxxxxxxxx>]

Yes.

I just finished a design for a 8 x 52" long sec coil with a simple dual
MOSFET solid state driver.  I'm making up the circuit boards for these
drivers, so we can furnish
a completely stuffed PCB with driver parts.  You just build a simple
enclosure, drop in the drive board, drop in a doubler circuit using the
parts I specify, and then mount your
coil and you are ready to go.

I have run a simulation and it produced 40 to 46" long sparks.

Contact me off list and I will give you my tel number so we can talk direct.

Dr. Resonance





On Fri, Jan 23, 2009 at 1:00 PM, Robert Byron <mustang_5l87@xxxxxxxxxxx>wrote:

>
> Hi All,
> Is it possible for someone with a very basic knowledge of electronics to
> construct a Solid State Coil? Or would I just be wasting my time and money?
>  I have attempted to replicate Steve Ward's mini SSTC and blew a few diodes.
> I would like to bring this off the shelf and complete it but I don't have
> the expensive tools or the experience to diagnose the problems.
> Rob._______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxxxxxx
> http://www.pupman.com/mailman/listinfo/tesla
>
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla