Re: [TCML] X-ray cable best practices for feeder cable

[Stan <wsmg@xxxxxxxxxx>]

Hey David,

When I did roofing we had shingle cutters that were a form of a hooked 
knife, but the one I'm talking about you can get to replace in a 
standard razor knife.(probably what your talking about)

Stan

David%20Rieben wrote:

> Hi Stan, 
>
>
>
> I assume that you're referring to the hooked 
>
> blade razor knives that roofers use to cut and 
>
> trim shingles.? 
>
>
>
> David Rieben 
>
>
>
> ----- Original Message ----- 
> From: "Stan" <wsmg@xxxxxxxxxx> 
> To: "Tesla Coil Mailing List" <tesla@xxxxxxxxxx> 
> Sent: Tuesday, January 6, 2009 9:47:28 AM GMT -06:00 US/Canada Central 
> Subject: Re: [TCML] X-ray cable best practices for feeder cable 
>
> Hey Jim, 
>
> The easiest way I found to strip the shield is with a hooked razor 
> knife. Cut the cover and the shield at the same time, the cover helps to 
> support the shield to cut easier. Watch the angle you keep the knife at 
> and the knife won't damage the insulator. 
>
> Hope this helps, 
> Stan 
>
> _______________________________________________ 
> Tesla mailing list 
> Tesla@xxxxxxxxxxxxxx 
> http://www.pupman.com/mailman/listinfo/tesla 
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxxxxxx
> http://www.pupman.com/mailman/listinfo/tesla
>
>
>  

_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla