[TCML] Topload design questions

[Karl Thorkildsen <karl.thorkildsen@xxxxxxxxxxxxx>]

First off, Hello!  I've been lurking for a while and have gained a 
huge amount of knowledge by reading hundreds of posts here.  I have 
built a couple of coils and am working on a third.  This will be run 
off two 15/60 NST's.

My question is about topload configurations.  I understand the need 
to have a toroid in close proximity to the top of the secondary to 
avoid corona discharge from the upper part of the primary.  But if 
using two toroids, can the upper (and larger) toroid be elevated a 
few inches on a conductive rod without adverse side effects?

For instance in my case I'm considering a 6.5x30 inch secondary, with 
a 3x12 and a 4x18 toroid and raising the 4x18 by 6 inches.

Why, you might ask?  Well, I originally thought of this as a way to 
reduce primary strikes, but I now realize this might only be valid 
under certain conditions.  Another consideration is that it would 
look cool.  But in the end I'm now just curious what the effect and 
ramifications might be.

Thoughts?
- Karl

_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla