[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [TCML] Questions on grounding
Jay (and Joe),
You do need a dedicated ground separate to your house ground of which
your bottom secondary should certainly be tied to. With the NST, you can
either connect the case to house ground or to this dedicated RF ground.
But, realize that if you connect the case to house ground, the "house"
components will have nasty RF spikes and transients running directly to
all of your appliances in the house. If you tie the NST case to RF
ground and end the house ground back at the control cabinet, you will
have far less electrical mess at your appliances. The choice is yours.
Anyone stating to "never connect the NST to the secondary RF ground" I
strongly disagree with. Look in the TCML archives as there are plenty of
discussions regarding this very issue which we've discussed many (many)
times (only a month ago I believe was the last blurb).
Take care,
Bart
jhowson4@xxxxxxxxxxx wrote:
First of all I am thinking that you need to connect the bottom of your secondary NOT to your NST. you need a separate ground for called the RF ground for the secondary.
The case and ground of the NST should be connected to your house ground and never connected to your secondary.
making the toroid really smooth will increase spark length. I have found that covering the tubing with plaster, sanding it smooth then covering it with aluminum duct tape, and smoothing that over with a spoon works really well. it is also beneficial to fill the interior of the tubing with some expanding foam to help prevent it from being crushed so easily. Here is a pic of my coil with the closest pic of the top load that I had.
http://i139.photobucket.com/albums/q295/JHowson/DSC06682.jpg
Jay Howson
----- Original Message -----
From: "jocatch" <jocatch@xxxxxxxxxxx>
To: tesla@xxxxxxxxxx
Sent: Tuesday, April 14, 2009 9:35:05 AM GMT -05:00 US/Canada Eastern
Subject: [TCML] Questions on grounding
Hello. I have built my first coil using standard parts and dimensions and have fired it up and so far I am producing sparks but only about 12" long. I am using a 12KV nst with .0125uf mmf, 13 turns of copper tubing as primary and 20" of #28 magnet wire on a 4" form with aluminum cloths dryer ducting for the toroid
My questions concerning grounding. I have read alot about discharge spark length but not much regarding how to measure it. Above I said 12" discharge spark length, that was to a key ring held at the end of a boom stick handle. Should the metal object that I am drawing the spark to be grounded? To earth ground? Right now nothing is grounded to earth or electrical ground. The bottom side of the secondary coil is connected to the metal case of the nst. Should the secondary coil and nst be grounded to earth ground?
Lastly, the aluminum toroid is discharging all around its circumference. I know the fewer discharge points on the top load, the bigger the discharge length will be. If I tape the toroid with aluminum tape to produce a smoother surface, will it help?
I have a web page showing photos of my first tesla coil before I recently updated it to copper tubing and new toriod. The web page shows the old primary wire coil and old topload. I will post new pictures of the update soon.
http://www.joecool.org/joe_s_tesla_coil.htm
Thanks for your help.
joe
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla